Wirepath WPS-700-DOM-A-WH Manual de instalación descargar pdf (Pagina 7)

WPS-700-DOM-A Installation Manual

4. Use the provided foam gasket as

a template to pre-mark mounting

hole locations. Position the camera

base at the desired location and

use the provided screws to attach

the camera base to the wall

or ceiling.

5. Using the supplied AC/DC plug,

connect the power supply jack

to 12-30 V DC or 24 VAC

and the BNC Video Output to

the desired video line.

WARNING – DO NOT CONNECT

POWER TO THE RS485 LEADS.

6. Once the camera is

installed, check the

viewing angle, zoom

and focus settings. To

adjust the zoom and

focus, loosen (but do

not remove), the set

screws. Using the set screws rotate the lens until you achieve the

desired setting. Once you have correctly set the zoom and focus,

tighten the set screws. Ensure the rubber lens gasket is in place.

7. Replace the dome cover to the dome base,

and make sure the screws on the dome cover

are tightened securely. Doing so seals the

dome from the elements, and creates a tight

 taroundtherubberlensgaskettoprevent

 theIRLEDsfromreectingintothelens.

12-30 V DC

or 24 V AC Power

BNC Video Output

RS485 Leads

White (+), Green(─)

AC/DC Plug

FOCUS

(Near-Far)

Rubber

Lens Gasket

ZOOM

(Tele-Wide)

NOTE : DO NOT remove the Silica Gel package

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Comentarios a estos manuales

Sin comentarios

Wirepath WPS-700-DOM-A-WH Manual de instalación Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Cámaras De Seguridad Wirepath WPS-700-DOM-A-WH