Wirepath WPS-700-DOM-A-BL Manual de instalación descargar pdf (Pagina 25)

WPS-565-DOM-A Installation Manual

7. Troubleshooting

If you have trouble operating the camera, rst refer to the following

guidelines. If the problem persists, contact Technical Support at (866)

838-5052.

Nothing appears on the display:

• Check if the power for the camera and the monitor is ON.

• Check if the VIDEO cable is connected to the camera BNC video

output jack.

• Check if the VIDEO cable is connected to the monitor VIDEO input

jack.

Image appears dim on the display:

• Check the monitor contrast setting.

• Check the monitor brightness setting.

• Check the lens. If necessary, clean with a soft, clean eyeglasses

cloth.

• Check if the camera is facing towards a bright light. If so, change

the camera position.

• If a device exists between the camera and screen, conrm the

signal accepted by the screen is strong enough – 75 Ohm.

Image appears blurry on the display:

• Check the focus of the lens.

• Check the lens. If necessary, clean with a soft, clean eyeglasses

cloth.

The camera is not working properly and the camera housing is hot:

• Check if camera is connected to the correct power source.

Condensation Appears on Camera Lens Cover:

• Add a new silica desiccant pack inside the camera housing.

Camera Power Cycles Intermittently:

• Check voltage at camera for proper voltage level.

• Connect camera locally with a different power supply to test.

1 2 ... 20 21 22 23 24 25 26 27 28

Sin comentarios

Wirepath WPS-700-DOM-A-BL Manual de instalación Pagina 25