Wirepath WPS-700-DOM-A-BL Manual de instalación descargar pdf (Pagina 7)

WPS-565-DOM-A Installation Manual

3. Wiring Recommendations

Wiring should be installed, terminated, and tested for connectivity before the

camera is installed. Specications for each connection are detailed below.

3.1. Wiring Connections

12V DC

Power In

BNC

Video Out

RS485 Leads

1. Power (Required)

It is recommended to install the camera power supply near the recording

location and run a remote power wire to the camera. Use the voltage drop

calculator at www.SnapAV.com to nd the correct gauge for a given length

of wire.

Pinout Wire Size (AWG) Power Requirements

—

Minimum 18 AWG

Calculate based on

voltage and wire

length

12V DC or 24V AC

(500mA minimum)

Included WPS-ACC-PWR-M is illustrated to demonstrate the correct polarity for power.

2. BNC Video Output (Required)

Install coaxial cable for transmitting video to a DVR or display monitor.

Recommended Cable Connector Type

RG-59 or RG-6

75-ohm rated BNC connectors

Use a BNC-RCA adapter for composite input

3. RS485 Communication +/- Wires (Optional)

Connect the RS485 wires to a controller or a Wirepath DVR to enable remote

access to the OSD setup menu.

Pinout Wire Size (AWG)

Camera Controller

Minimum 24 AWG

2 Cat5e/6 conductors or 2-conductor alarm wire is

recommended

(White)

(Positive)

(Green)

(Negative)

Important! Separate and insulate the ends of the RS485 wires if they will not be

connected. DO NOT connect the + and - wires together.

1 2 3

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Comentarios a estos manuales

Sin comentarios

Wirepath WPS-700-DOM-A-BL Manual de instalación Pagina 7

Comentarios a estos manuales