Wirepath WPS-700-DOM-A-BL Manual de instalación descargar pdf (Pagina 9)

WPS-565-DOM-A Installation Manual

Step 2. Mount the Camera

Using Mounting Accessories

Mount the accessory according to its instructions, make

wiring connections, and mount the camera. Then,

continue these instructions below at Step 3 to complete

camera installation.

Surface Mounting

A. Use the included template to mark the screw loca-

tions for mounting.

B. Connect the camera to the wiring and move it into

position. Avoid pinching the wires between the cam-

era and the mounting surface.

C. Use 3 of the included screws to secure the camera.

Insert the screws through the black mounting hole

gaskets and hand-tighten them evenly.

Step 3. Adjust Focus, Zoom, and Menu Settings

See “Camera Operation Setup” beginning on the

next page for instructions. Set the focus and zoom

adjustments, and adjust the OSD Setup Menu options as

needed. Disconnect the test adapter after completing

adjustments.

Step 4. Close the Camera

DO NOT remove the factory-installed silica desiccant packet in the camera.

A. Before closing the camera, remove

the spare silica packet from its

sealed foil package (taking care

not to rip the inner packet) and

place it inside the camera, out of

the lens’ eld of view. Do not re-

move the existing silica gel packet

strapped inside the camera.

B. Close the camera dome and use

the 3mm Allen wrench to tighten

the screws evenly. Remove the out-

erdomeprotectivelmlast.

Factory Silica Pack

(attached to wire)

Place New Pack

Behind Gimbal

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Sin comentarios

Wirepath WPS-700-DOM-A-BL Manual de instalación Pagina 9